5 Old Wiring Tricks Electricians Still Use Today

If you are to take one pro tip from us then the best electrician is always known by the way he thinks outside the wires and makes magic happen. And to shed light on how electricians from generations have made that happen with a large number of trial and error, we have listed down some of the top 5 old electrician wiring tips that will help you improve your skill and reputation as the best electrician in Paradise Valley AZ.

Always Use The End of Hanger To Identify The Drilling Position

Do you start measuring up from the foundation to find the drilling spot in the wall? If the answer is yes then this traditional way is a brilliant alternative in which all you are required to do is take an insulation or coat hanger and snip it off from the ends at about 45 degrees. The next step involves inserting the hanger in your drill and then you can make a small hole at 45 degrees on the floor - right next to the molding.

The best part about this trick is that homeowners are never going to notice the hole as well because it is going to be that small.

Using Hot Air Gun For Bending PVC Conduit

A hot air gun can help you a great deal in a quick bend for PVC conduit. All you are required to do is heat the required area till the moment it becomes pliable and then you can bend. If there are larger conduits, you can bend them by inserting the area of a conduit inside a 3 or 4 inch PVC tee and the hot air gun should be in the remaining opening of the tee. You should just leave the conduit in the tee until it becomes bendable. 

Paper Can Hold A Screw On The Screwdriver

You can use a piece of paper that is about ½” by ½” to wrap up the head of the screwdriver and it will slip inside the slot of the screw. This trick, however, can also work the best if the slot is deep because you will be required to bend the paper for once more to tighten the slot. This also works the best in the case of nut-drivers as well.

Keep The Wires Dry With The Help of Silicon

This is that one idea which is going to be more useful if you are required to work underground or around damp locations. All you have to do is take a bit of silicon and squirt it in the wire nut to keep the water and moisture out. As soon as the silicon dries up, it becomes airtight.

Easy Clean-Up

All you need is a cheap 2” paintbrush which should be in your toolbox. This small brush is going to become really handy for when you will have to clean dust and metal shavings from panels and boxes.